6 ArmorBlock 16-Point EtherNet/IP Module, Series A
Publication
1732E-IN002B-EN-E - February 2011
Catalog Number Explanation
Refer to the table for a description of the catalog numbers.
Install the Module
Refer to the following sections to install your module.
• Set the Network Address
• Mount the Module
• Connect the I/O, Network and Auxiliary Cables to the ArmorBlock
Module
Set the Network Address
The I/O block ships with the rotary switches set to 999 and DHCP-enabled.
To change the network address, you can do one of the following:
• adjust the switches on the front of the module.
• use a Dynamic Host Configuration Protocol (DHCP) server, such as
Rockwell Automation BootP/DHCP.
• retrieve the IP address from nonvolatile memory.
The I/O block reads the switches first to determine if the switches are set to a
valid number. Set the network address by adjusting the 3 switches on the front
Cat. No. Description Network
Connector
Auxiliary
Power
1732E-IB16M12 EtherNet 24V DC 16 Input
Single D-Code M12
Single 4-pin
mini
1732E-OB16M12 EtherNet 24V DC 16, 2 A Output
1732E-16CFGM12 EtherNet 24V DC 16 Selectable
Points
1732E-IB16M12W EtherNet 24V DC 16 Input
WeldBlock Metal Housing
Single D-Code M12
Single 4-pin
mini1732E-16CFGM12W EtherNet 24V DC 16 Selectable
Points
WeldBlock Metal Housing
Comments to this Manuals