Rockwell-automation 1753-IB8XOB8 GuardPLC 8-Digital Inputs and 8-Digit User Manual download pdf (Page 16)

16 GuardPLC 8-Digital Inputs and 8-Digital Outputs Module

Publication 1753-IN010A-EN-P - October 2005

Reset Pushbutton

You can use the reset button if you forget the password for connecting the

programming software. The pushbutton is accessible through a small round hole at

the top of the housing, approximately 4 to 5 cm (1.6 to 2.0 in.) from the left rim and

recessed approximately 9.5 mm (0.375 in.).

To reset, press and hold the pushbutton for 20 seconds while rebooting the device

by cycling power. Pressing the Reset pushbutton during operation has no affect.

With activation of the reset button:

• All accounts are deleted except for the default account.

• IP address and system ID (SRS) are set to default values.

At the next power cycle, these settings will be restored to the last values stored into

Flash. This means that either:

• the settings prior to the reset will be restored, or

• if any settings were changed after the reset, these new settings will still be in

effect.

IMPORTANT

Activate the reset pushbutton using an insulated pin to prevent

short-circuits.

1 2 ... 11 12 13 14 15 16 17 18 19 20

No comments

Rockwell-automation 1753-IB8XOB8 GuardPLC 8-Digital Inputs and 8-Digit User Manual Page 16