A–B
3
Chapter
3–1
Installation
Contents
Chapter Objectives 3–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Installing the MATH-PAK Option 3–1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
This chapter describes how to install the MATH-PAK option in the
Allen–Bradley 5370–CVIMC Color CVIM module.
The MATH-PAK option is provided on the supplied memory card. This
section describes how to install the MATH-PAK option. Please note the
following considerations:
Required Firmware: The Color CVIM module must have the Revision
A02 (or higher) firmware before the MATH-PAK option can be installed
(the firmware revision is listed on the title banner on the monitor screen
following powerup).
One–Time Installation: You need only install the MATH-PAK option
once; once installed, the MATH-PAK option remains installed for all
subsequent powerups.
To install the MATH-PAK option in your Color CVIM module:
• Remove DC power from the Color CVIM module.
• Insert the MATH-PAK installation card into the Archive Memory slot on
the Color CVIM module. Insert the end with the metal strip facing right
(see Figure 3.1, page 3–2).
• Restore DC power to the Color CVIM module – this starts the loading
sequence.
!
ATTENTION: Do not remove power to the Color CVIM
module during loading of the MATH-PAK option. Doing so may
damage the Color CVIM module.
Chapter Objectives
Installing the MATH-PAK
Option
Comments to this Manuals