Rockwell-automation MinPak Plus DC Drive Reversing Contactor Kit NRG, User Manual download pdf

Reliance and MinPak are trademarks of Rockwell Automation.

Reversing Contactor Kit

for Non-Regenerative MinPak Plus DC Drives

Model Numbers 14C217 and 14C218

Instruction Manual D2-3377

Product Description

Installation of the Reversing Contactor enables a single-phase, non-regenerative MinPak™ Plus DC drive to

provide both forward and reverse motor control. The standard factory-shipped drive offers unidirectional motor

control only.

When the Reversing Contactor is installed, the drive’s M-contactor is the forward contactor. Motor direction is

manually selected using the forward/reverse switch on the local or remote operator’s control station. Refer to

your MinPak Plus DC drive instruction manual for information on the operator’s control station.

The Reversing Contactor kit and drive horsepower rating must be compatible. Refer to table 1.

The Reversing Contactor is pre-assembled. All of the necessary jumper wires and mounting hardware are

included with the kit. The contents of the kit are listed in table 2.

ATTENTION:Only qualified electrical personnel familiar with the construction and operation of

this equipment and the hazards involved should install, adjust, operate, and/or service this

equipment. Read and understand this manual and other applicable manuals in their entirety

before proceeding. Failure to observe this precaution could result in severe bodily injury or loss

of life.

Table 1 – Reversing Contactor and Drive Horsepower Compatibility

Drive Model Number Drive Horsepower Kit Model Number

14C10, 14C20, 14C11, 14C21, 14C12, 14C22 1/4 to 3 14C217

14C13, 14C23 5 14C218

Table 2 – Contents of the Reversing Contactor Kit

Description Quantity

Part Number

M/N14C217 M/N14C218

Reversing Contactor 1 69326-26R 69326-25R

Wire Harness 45/47 1 700867-67S 700867-67V

Wire Harness A1/A2 1 700867-67R 700867-67T

5-wire Control Harness with Connector 1 700867-63R

Mounting Screw, 8-32 x 3/16 3 601741-62C

Instruction Manual 1 D2-3377

1 2 3 4 5 6

Summary of Contents

Page 1 - Reversing Contactor Kit

Page 2

2Reversing Contactor Kit for Non-Regenerative MinPak Plus DC DrivesInstalling the Reversing ContactorImportant:If a Dynamic Braking kit will be instal

Page 3 - Figure 1 – Wiring Connections

Reversing Contactor Kit for Non-Regenerative MinPak Plus DC Drives3Step 8. Using a wire cutter, remove jumper J9, located below the “REV” connector, f

Page 4

Page 5

Page 6

U.S. Drives Technical Support Tel: (1) 262.512.8176, Fax: (1) 262.512.2222, Email: [email protected], Online: www.ab.com/support/abdrives

Comments to this Manuals

No comments

Rockwell-automation MinPak Plus DC Drive Reversing Contactor Kit NRG, User Manual

Browse online or download User Manual for Equipment Rockwell-automation MinPak Plus DC Drive Reversing Contactor Kit NRG, . Rockwell Automation MinPak Plus DC Drive Reversing Contactor Kit NRG, 14C217, 14C218 User Manual

Summary of Contents

Comments to this Manuals

Related products and manuals for Equipment Rockwell-automation MinPak Plus DC Drive Reversing Contactor Kit NRG,