Publication 1771-RN953E-EN-P - February 2005
Release Notes
1771-SDN Series C
DeviceNet Scanner Module
Cat. No. 1771-SDN/C, Revision 6.007
Purpose
These release notes describe enhancements, corrected anomalies and other
important information for this revision and previous revisions of the
1771-SDN DeviceNet
TM
scanner module.
Use this document with the 1771-SDN DeviceNet Scanner Module User
Manual, publication 1771-UM118, available online at
www.rockwellautomation.com/literature.
What This Document
Describes
Module Compatibility and
Maintenance Requirements
The Series C scanner module is fully compatible with the Series A and Series B
versions. You can use the Series C version as a spare or replacement module
with one requirement: you must change the position of Switch 5 to the off or 0
position in the Configuration switchbank as shown below:
For Information About See page
Module Compatibility and Maintenance Requirements below
Electronic Data Sheet Requirement 2
Software Requirement 2
Revisions 6.007, 6.006 and 6.005 2
Revision 6.004 Enhancement 2
Revision 6.003 Enhancements 3
Configuration
20277
Chassis Address
Series C label
NOTE: Default scanner setting is Series C operation.
When replacing an older scanner, set
configuration switch 5 to the OFF position.
See Installation Instructions for details.
Comments to this Manuals