Rockwell-automation 1734-AENT, Series B 1734 POINT I/O EtherNet/IP Ada User Manual download pdf (Page 10)

10 1734 POINT I/O EtherNet/IP Adapter

Publication 1734-IN042B-EN-P - October 2013

2. Press down firmly to install the adapter on a DIN rail, noting that the locking

mechanism locks the adapter to the DIN rail.

3. Set the network address thumbwheel switches to the desired value. See Set the

Network Address for more information on setting the IP address.

4. Slide the safety end cap up to remove it, exposing the backplane and power

interconnections.

ATTENTION: Do not discard the end cap. Use this end cap to cover the

exposed interconnections on the last mounting base on the DIN rail. Failure to

do so could result in equipment damage or injury from electric shock.

ATTENTION: This product is grounded through the DIN rail to chassis ground.

Use zinc plated yellow-chromate steel DIN rail to assure proper grounding. The

use of other DIN rail materials (for example, aluminum or plastic) that can

corrode, oxidize, or are poor conductors, can result in improper or intermittent

grounding. Secure DIN rail to mounting surface approximately every 200 mm

(7.8 in.) and use end-anchors appropriately.

ATTENTION: Allow 25.4 mm (1 in.) of space between adjacent equipment for

adequate ventilation.

WARNING: If you connect or disconnect the communications cable with

power applied to this module or any device on the network, an electrical arc

can occur. This could cause an explosion in hazardous location installations.

Be sure that power is removed or the area is nonhazardous before proceeding.

ATTENTION: Do not remove or replace an Adapter Module while power is

applied. Interruption of the backplane can result in unintentional operation or

machine motion.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 23 24

No comments

Rockwell-automation 1734-AENT, Series B 1734 POINT I/O EtherNet/IP Ada User Manual Page 10