Rockwell-automation 2364P Overhead Bus for Bulletin 2300 MCCs User Manual download pdf (Page 4)

Publication 2364P-5.10 - December 1999

Note: Verify that there is sufficient working space above and around

the MCCs. If not, install the bus tabs and splices before placing the bus

assemblies on the MCC sections.

1. Remove the bus assembly mounting screws from the MCCs as shown

in Figure 3, Step 1. These screws will be used in step 7 to mount the

bus assemblies to the MCCs.

2. With the Certified Cabinet Outline Drawing as a guide, place all of the

assemblies onto the MCC sections (as shown in Figure 3, Step 2).

Align the mounting holes in the rear of the MCC. Do not fasten the

assemblies to the MCCs at this time.

3. Place an insulator over each set of 3-phase busbars to be spliced, includ-

ing the busbars to be spliced to the feeder (see Figure 3, Step 3).

Figure 3

Installation Example–Steps 1 - 3

#10 Taptite

Screws (typ.)

Insulator

Step

20 in

(51mm)

1 2 3 4 5 6 7 8

No comments

Rockwell-automation 2364P Overhead Bus for Bulletin 2300 MCCs User Manual Page 4