Rockwell-automation 2706-PENI_PDNI InView EtherNet/IP Module and InVie User Manual download pdf (Page 6)

Publication 2706-IN010C-MU-P

6 InView EtherNet/DeviceNet Module

Open the front of the sign case (on 2706-P7x) by turning the

latches to the left. Carefully let the front of the case drop

forward.

3. Feed the serial cable through the cable grip (shipped with

module).

4. Insert the serial wires through the right conduit opening on

either the top or the bottom of the InView display.

5. Mount the cable grip to the InView display housing. Tighten the

locknut finger-tight and rotate an additional 1/2 turn.

6. Connect the incoming serial wires to the TB1 terminal block.

POWER

LOAD

EARTH

GROUND

Quarter-turn latches

Front view, closed

Front view, open

EPROM unit (on

underside of board)

Controller board

2706-P72,

2706-P74

Power Line

Insert the serial wires

with the cable grip into

one of these conduit

openings.

TB1 Terminal Block for serial connection

Incoming

serial wires

TB1

(NC) 8

(NC) 7

(NC) 6

(NC) 5

(RS-232 RX) 4

(RS-232 TX) 3

(NC) 2

(GND) 1

Brown (Rxd)

Orange (Txd)

Blue (GND)

TB1 Terminal Block

1 2 3 4 5 6 7 8 9 10 11 ... 52 53

Comments to this Manuals

No comments

Rockwell-automation 2706-PENI_PDNI InView EtherNet/IP Module and InVie User Manual Page 6

Comments to this Manuals

Related products and manuals for Equipment Rockwell-automation 2706-PENI_PDNI InView EtherNet/IP Module and InVie