Rockwell-automation 6189x Integrated Display Industrial Computers User User Manual download pdf (Page 46)

46 Rockwell Automation Publication 6181P-UM003A-EN-P - May 2014

Chapter 4 Component Replacement

Reinstall the Cover

Follow these steps to reinstall the rear cover (a display computer is shown).

1. Follow steps 1…3 for Post-configuration

on page 45.

2. Reattach the rear cover to the chassis (1).

3. Close the cover (2).

4. Tighten the three screws to secure the rear cover (3).

5. Follow steps 4 and 5 for Post-configuration

on page 45.

CompactFlash Card

The computers have a CompactFlash (CF) Type II card slot for loading CF cards

on the I/O port panel below the serial ports. See

Hardware Features

starting on

page 13

for the CF card slot location.

Follow these steps to load a CF card.

1. Loosen the two screws that secure the CF card slot cover.

2. Remove the CF card slot cover.

3. Insert the CF card into the slot until it is firmly seated.

4. Reattach the CF card slot cover.

5. Tighten the two screws to secure the slot cover.

Integrated Display

Model Shown

IMPORTANT

The CF card slot is a bootable slot for DOS and Linux operating systems but not

for Windows operating systems.

You can insert or remove a FAT32 formatted CF card from this slot while the

computer is on. For a NTFS formatted CF card, use the Windows ‘Safely Remove/

Eject Media’ process.

ATTENTION:

When properly seated, more than 80% of the CF card easily

inserts into the slot before you encounter resistance. If you encounter

resistance before then, remove the card, rotate it 180°, and reinsert.

Do not force the card into the slot. Forcing the card into the slot can

damage the connector pins.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 123 124

No comments

Rockwell-automation 6189x Integrated Display Industrial Computers User User Manual Page 46