Rockwell-automation T3470A ICS Regent Analogue Output Modules User Manual

ICS Regent® PD-6025 Industrial Control Services 1 Analog Output Modules 4 to 20 mA (T3470A) Issue 1, March, 06 Analog output modules provide 4 to 2

Analog Output Modules (T3470A) 10 Industrial Control Services 1) Set the Module Type: Position the cursor on the module slot you wish to define.

Analog Output Modules (T3470A) PD-6025 Mar-06 11 Figure 7. Defining an Analog Output Point. Name Also called the tag name, this is the name use

Analog Output Modules (T3470A) 12 Industrial Control Services Programming Outputs are controlled by writing application programs that solve for ou

Analog Output Modules (T3470A) PD-6025 Mar-06 13 control logic, you maintain the full resolution of the analog output (1 part in 4096) and have a

Analog Output Modules (T3470A) 14 Industrial Control Services Figure 9). During the calibration steps you will remove the printed circuit board f

Analog Output Modules (T3470A) PD-6025 Mar-06 15 precision load resistors to the analog outputs. Figure 10 shows the jumper posts to which you s

Analog Output Modules (T3470A) 16 Industrial Control Services 2. Install the I/O extender module into the slot from which the module was removed.

Analog Output Modules (T3470A) PD-6025 Mar-06 17 analog output module to the factory for repair or replacement. 14. Calibration is complete. Unp

Analog Output Modules (T3470A) 18 Industrial Control Services Heat Dissipation 10 Watts, 33 BTUs/hour Operating Temperature 0° to 60° C (32° to 14

Analog Output Modules (T3470A) 2 Industrial Control Services module from affecting module operation). The voted result is then passed to the I/O

Analog Output Modules (T3470A) PD-6025 Mar-06 3 to return the correct majority-voted result to the processors produces an I/O module error indic

Analog Output Modules (T3470A) 4 Industrial Control Services Figure 2. Analog Output Module.

Analog Output Modules (T3470A) PD-6025 Mar-06 5 Shutdown Indicator Upon loss of communications with the controller, output modules enter either

Analog Output Modules (T3470A) 6 Industrial Control Services For high integrity applications requiring fail-safe or fault tolerant analog outputs

Analog Output Modules (T3470A) PD-6025 Mar-06 7 Figure 4. Module Wiring.

Analog Output Modules (T3470A) 8 Industrial Control Services Fault Mode Jumper The fault mode jumper is located behind the ID switch cover in the

Analog Output Modules (T3470A) PD-6025 Mar-06 9 Figure 5. Installing Slot Keys. Configuration Each output module is configured using the WIN