Rockwell-automation 1394-SR10A External Shunt Resistor Kit User Manual download pdf (Page 4)

3. Install the jumper block in the P1 position, which is located

directly behind the Status LED, as shown in Figure 3.

4. Install and tighten the resistor wire with the fuse in the DC+

terminal on the power terminal block in the lower right corner.

5. Install and tighten the other resistor wire in the COL terminal on

the power terminal block in the lower right corner.

6. Re-apply power and resume operation. Refer to the 1394 Digital,

AC, Multi-Axis Motion Control System User Manual (publication

1394-5.0) for startup information.

Important: Use fuse replacement kit (1394-SR10A-FUSE-A) when

replacing the 1394-SR10A shunt fuse. Refer to the 1394

Digital, AC, Multi-Axis Motion Control System User

Manual (publication 1394-5.0) for additional

information regarding fuse replacement kits.

Jumper

block to P1

1 2 3 4 5 6

No comments

Rockwell-automation 1394-SR10A External Shunt Resistor Kit User Manual Page 4