Rockwell-automation 1758-RTU202 DataSite Hardware User Manual User Manual Page 12
- Page / 68
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Publication 1758-UM001D-EN-P - June 2011
12 Installing the Controller
Locate your controller as far as possible from power lines, load lines, and other
sources of electrical noise such as hard-contact switches, relays, and AC motor
drives. For more information on proper grounding guidelines, see the Industrial
Automation Wiring and Grounding Guidelines, publication 1770-4.1
.
Safety Considerations
Safety considerations are an important element of proper system installation.
Actively thinking about the safety of yourself and others, as well as the
condition of your equipment, is of primary importance. We recommend
reviewing the following safety considerations.
Hazardous Location Considerations
This equipment is suitable for use in Class I, Division 2, Groups A, B, C, D
locations only. The following WARNING statement applies to use in
hazardous locations.
ATTENTION
Electrostatic discharge can damage semiconductor devices
inside the controller. Do not touch the connector pins or other
sensitive areas.
ATTENTION
Be careful of metal chips when drilling mounting holes for your
controller or other equipment within the enclosure or panel.
Drilled fragments that fall into the controller could cause
damage. Do not drill holes above a mounted controller if the
protective debris strips have been removed.
WARNING
EXPLOSION HAZARD
• Substitution of components may impair suitability for
Class I, Division 2.
• Do not replace components or disconnect equipment unless
power has been switched off.
• Do not connect or disconnect components unless power
has been switched off.
• This product must be installed in an enclosure. All cables
connected to the product must remain in the enclosure or
be protected by conduit or other means.
• All wiring must comply with N.E.C. article 501-10(b).
- Remote Terminal Unit 1
- Important User Information 2
- Table of Contents 3
- Chapter 4 4
- Operating the Controller 4
- Appendix A 4
- Specifications 4
- Who Should Use this 5
- Purpose of this Manual 5
- Related Documentation 5
- Common Techniques Used 6
- Overview 7
- 1758-FLO DataSite controllers 8
- Features at a Glance 8
- Controller Description 9
- 10 Overview 10
- Installing the Controller 11
- Safety Considerations 12
- Environnements dangereux 13
- Disconnecting Main Power 14
- Safety Circuits 14
- Power Considerations 15
- Preventing Excessive Heat 16
- Master Control Relay 17
- Using the Lithium Battery 18
- Controller Mounting 19
- Dimensions 19
- Controller Spacing 19
- Mounting the Controller 20
- DIN rail 21
- Wiring the Controller 23
- Wiring Requirements 24
- Wiring the Terminal Block 25
- Power Source 28
- Requirements 28
- Grounding the Controller 29
- Power Wiring 29
- I/O Wiring 30
- 23456789101 31
- 40 41 42 43 44 45 31
- Grounding Your Analog Cable 32
- Wiring for Digital Input (DI) 33
- 12…24 V DC 33
- 11 12 13 14 15 16 34
- Filter PI0 35
- Filter PI1 35
- Filter PI2 35
- RS232 DB-9P Connector 36
- RS232 (DTE) 37
- RS232 (DTE) DTE 38
- RS232 (DTE) DCE 38
- RS485 Port 39
- Termination Resistors 41
- 3332 3534 42
- Ethernet RJ-45 connector 43
- Ethernet cable 43
- Ethernet RJ-45 44
- PC RJ-45 44
- Switch RJ-45 44
- Wiring for Wake Up mode 45
- 12…24V DC 45
- LED Indicators 48
- Power Control 49
- Counter Input Filters 50
- Real-Time Clock 51
- Modbus Register 51
- Assignment 51
- Assigned Modbus Register 52
- Addresses of I/O Signals 52
- Scan Settings of Equipment 53
- Connected with COMs 53
- RS485/RS232 Switch 53
- Settings 53
- Communication Parameters 53
- Lithium Battery 54
- IMPORTANT 55
- LITHIUM BATTERY 57
- 60 Specifications 60
- Specifications 61 61
- 62 Specifications 62
- Specifications 63 63
- 64 Specifications 64
- Specifications 65 65
- Flow Measurement 66
- Parameters 66
- Rockwell Automation Support 68
- Documentation Feedback 68
Related products and manuals for Equipment Rockwell-automation 1758-RTU202 DataSite Hardware User Manual
Equipment Rockwell-automation 1769-XXXX Compact I/O Communication Bus Expansion User Manual
(12 pages)
(12 pages)
Equipment Rockwell-automation 1747-ACNR15 ControlNet Adapter Module User Manual User Manual
(140 pages)
(140 pages)
Equipment Rockwell-automation 1769-BOOLEAN Compact I/O Module Reference Manual User Manual
(98 pages)
(98 pages)
Equipment Rockwell-automation 1771-OWN Selectable Contact Installation Instructi User Manual
(16 pages)
(16 pages)
Equipment Rockwell-automation 1756-OF8H ControlLogix HART Analog I/O Modules User Manual
(228 pages)
(228 pages)
Equipment Rockwell-automation 1791-32AO SERIES B 32 Input AC Block I/O Module User Manual
(12 pages)
(12 pages)
Equipment Rockwell-automation 1769-IF4FXOF2F Compact Combination Fast Analog I/O User Manual
(28 pages)
(28 pages)
Equipment Rockwell-automation 1769-IF16V Compact High Density Analog Voltage Inp User Manual
(28 pages)
(28 pages)
Equipment Rockwell-automation 1771-IXE/D Thermocouple/Millivolt Input Module Use User Manual
(85 pages)
(85 pages)
Equipment Rockwell-automation 1747-AENTR SLC 500 EtherNet/IP Adapter User Manual User Manual
(84 pages)
(84 pages)
Equipment Rockwell-automation 1771-P4S_P6S_P4S1_P6S1 Power Supply Modules Instal User Manual
(16 pages)
(16 pages)
Equipment Rockwell-automation 1746-RT34 SLC 500 Thermocouple/mV Input Module Ter User Manual
(2 pages)
(2 pages)
© 2020, manymanuals.com. All rights reserved. | 0.349 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals