Rockwell-automation 1758-RTU202 DataSite Hardware User Manual User Manual download pdf (Page 21)

Publication 1758-UM001D-EN-P - June 2011

Installing the Controller 21

4. Slide the clamp out while pushing the controller fully onto the DIN

rail (1). When the controller is properly aligned on the DIN rail (2), slide

the clamp in, so that it make direct contact with the lower edge of the

DIN rail (3).

5. Tighten the clamp screws.

Follow these steps to remove your controller from the DIN rail.

1. Loosen the two clamp screws until the clamp can slide out, taking care

not to dislodge the clamp screws from the clamp.

2. Remove the controller.

44538 44539 44540

DIN rail

123

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 67 68

Remote Terminal Unit 1
Important User Information 2
Table of Contents 3
Chapter 4 4
Operating the Controller 4
Appendix A 4
Specifications 4
Who Should Use this 5
Purpose of this Manual 5
Related Documentation 5
Common Techniques Used 6
Overview 7
1758-FLO DataSite controllers 8
Features at a Glance 8
Controller Description 9
10 Overview 10
Installing the Controller 11
Safety Considerations 12
Environnements dangereux 13
Disconnecting Main Power 14
Safety Circuits 14
Power Considerations 15
Preventing Excessive Heat 16
Master Control Relay 17
Using the Lithium Battery 18
Controller Mounting 19
Dimensions 19
Controller Spacing 19
Mounting the Controller 20
DIN rail 21
Wiring the Controller 23
Wiring Requirements 24
Wiring the Terminal Block 25
Power Source 28
Requirements 28
Grounding the Controller 29
Power Wiring 29
I/O Wiring 30
23456789101 31
40 41 42 43 44 45 31
Grounding Your Analog Cable 32
Wiring for Digital Input (DI) 33
12…24 V DC 33
11 12 13 14 15 16 34
Filter PI0 35
Filter PI1 35
Filter PI2 35
RS232 DB-9P Connector 36
RS232 (DTE) 37
RS232 (DTE) DTE 38
RS232 (DTE) DCE 38
RS485 Port 39
Termination Resistors 41
3332 3534 42
Ethernet RJ-45 connector 43
Ethernet cable 43
Ethernet RJ-45 44
PC RJ-45 44
Switch RJ-45 44
Wiring for Wake Up mode 45
12…24V DC 45
LED Indicators 48
Power Control 49
Counter Input Filters 50
Real-Time Clock 51
Modbus Register 51
Assignment 51
Assigned Modbus Register 52
Addresses of I/O Signals 52
Scan Settings of Equipment 53
Connected with COMs 53
RS485/RS232 Switch 53
Settings 53
Communication Parameters 53
Lithium Battery 54
IMPORTANT 55
LITHIUM BATTERY 57
60 Specifications 60
Specifications 61 61
62 Specifications 62
Specifications 63 63
64 Specifications 64
Specifications 65 65
Flow Measurement 66
Parameters 66
Rockwell Automation Support 68
Documentation Feedback 68

Comments to this Manuals

No comments

Rockwell-automation 1758-RTU202 DataSite Hardware User Manual User Manual Page 21

Comments to this Manuals

Related products and manuals for Equipment Rockwell-automation 1758-RTU202 DataSite Hardware User Manual