Rockwell-automation GV3000/SE AC Bookshelf Drive Hardware Ref, Install User Manual download pdf (Page 29)

Planning Before Installing

3-1

HAPTER

Planning Before Installing

This chapter describes how to plan a GV3000/SE Bookshelf drive installation.

3.1 General Requirements for the Installation Site

It is important to properly plan before installing a GV3000/SE Bookshelf drive to

ensure that the drive’s environment and operating conditions are satisfactory. Note

that no devices are to be mounted behind the drive. This area must be kept clear of all

control and power wiring. Read the following recommendations before continuing with

drive installation.

3.1.1 Making Sure Environmental Conditions are Met

Before deciding on an installation site, consider the following guidelines:

•

Verify that drives can be kept clean, cool, and dry.

•

The area chosen should allow the space required for proper air flow as defined in

section 3.1.3.

•

Be sure that drives are away from oil, coolants, or other airborne contaminants.

ATTENTION:

Only qualified electrical personnel familiar with the

construction and operation of this equipment and the hazards involved

should install, adjust, operate, or service this equipment. Read and

understand this manual and other applicable manuals in their entirety

before proceeding. Failure to observe this precaution could result in

severe bodily injury or loss of life.

ATTENTION:

When the level-sense start feature is enabled

(P.054 = ON), the user must ensure that automatic start up of the driven

equipment will not cause injury to operating personnel or damage to the

driven equipment. In addition, the user is responsible for providing

suitable audible or visual alarms or other devices to indicate that this

function is enabled and the drive may start at any moment. Refer to the

GV3000/SE Bookshelf Drive Software Start-Up and Reference manual

(D2-3426) for additional information. Failure to observe this precaution

could result in severe bodily injury or loss of life.

ATTENTION:

Use of power correction capacitors on the output of the

drive can result in erratic operation of the motor, nuisance tripping, and/or

permanent damage to the drive. Remove power correction capacitors

before proceeding. Failure to observe this precaution could result in

damage to, or destruction of, the equipment.

ATTENTION:

The user is responsible for conforming with all applicable

local, national, and international codes. Failure to observe this precaution

could result in damage to, or destruction of, the equipment.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 95 96

Comments to this Manuals

No comments

Rockwell-automation GV3000/SE AC Bookshelf Drive Hardware Ref, Install User Manual Page 29

Comments to this Manuals

Related products and manuals for Equipment Rockwell-automation GV3000/SE AC Bookshelf Drive Hardware Ref, Install