Rockwell-automation W-Series Brushless Servo Motor User Manual download pdf (Page 9)

W-Series Motor Installation Instructions 9

Publication 1398-IN520A-EN-P — May 2001

Installing Your Motor

W-Series motors include a mounting pilot for aligning the motor on a

machine. Preferred fasteners are stainless steel. The installation must

comply with all local regulations and use of equipment and installation

practices that promote electromagnetic compatibility (EMC) and safety.

Allow sufficient clearances in the area of the motor for it to stay within its

specified operating temperature range, 0° to 40° C (32° to 104° F). Do not

enclose the motor unless forced air is blown across the motor for cooling.

A fan blowing air across the motor will improve its performance. Keep

other heat producing devices away from the motor.

Refer to Mounting Dimensions on page 14 to determine the mounting

dimensions of your motor.

ATTENTION

Unmounted motors, disconnected mechanical couplings,

and/or disconnected cables are dangerous if power is

applied.

Disassembled equipment should be appropriately

identified (tagged-out) and access to electrical power

restricted (locked-out).

Failure to observe these safety procedures could result in

personal injury.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

No comments

Rockwell-automation W-Series Brushless Servo Motor User Manual Page 9