Rockwell-automation 57C435 Processor Module, AutoMax User Manual download pdf (Page 43)

CĆ1

Appendix C

Connecting the AutoMax Processor

to the Personal Computer

If it is necessary to prepare a cable to connect a personal computer to the

AutoMax Processor, follow the steps below. See the PC3000 User Manual

(J2Ć3096) for more information about connecting the PC3000 processor to the

personal computer.

WARNING

THE FOLLOWING INSTRUCTIONS ARE INTENDED ONLY TO ALLOW

FABRICATION OF PROPER CONNECTIONS BETWEEN RELIANCE EQUIPMENT

AND USERĆPROVIDED PROGRAMMING DEVICES. THE USER MUST READ AND

UNDERSTAND ALL APPLICABLE INSTRUCTION MANUALS PRIOR TO

OPERATING THE EQUIPMENT. FAILURE TO OBSERVE THIS PRECAUTION

COULD RESULT IN BODILY INJURY.

1. Determine whether your programming terminal contains a 9Ć or 25Ćpin male

connector.

2. Cut a suitable length (not to exceed 10 feet) of 22Ćgauge, multiĆconductor

cable.

3. Follow the connector manufacturer's instructions and make cable

connections using figure 1 or 2, whichever is applicable.

4. Check for grounds, shorts, and continuity using an Ohm meter.

Programming Terminal End of Cable

25ĆPin Female Connector

Reliance End of Cable

25ĆPin Male Connector

SIGNAL PIN#

RECV ă3

XMIT ă2

CTS ă5

RTS ă4

DTR 20

DSR ă6

COM ă7

PIN# SIGNAL

ă2 XMIT

ă3 RECV

ă4 RTS

ă5 CTS

ă6 DSR

20 DTR

ă7 COM

Figure 1

1 2 ... 38 39 40 41 42 43 44 45 46 47 48 ... 59 60

Comments to this Manuals

No comments

Rockwell-automation 57C435 Processor Module, AutoMax User Manual Page 43

Comments to this Manuals

Related products and manuals for Equipment Rockwell-automation 57C435 Processor Module, AutoMax