Rockwell-automation 7000 PowerFlex HMI Offering with Enhanced Function User Manual download pdf (Page 30)

28 Rockwell Automation Publication 7000-UM201B-EN-P - June 2013

Chapter 3 Forge Shell

Troubleshooting

The icons displayed in the Forge Shell program can take on three forms as shown

in Figure 23

Figure 23 - Drive Icon Status

A normal icon (with no X) is a HMI Interface Board module and drive which is

currently online and active. The name displayed for the drive is that obtained

from the Drive. If the name is missing, then no name has been assigned to the

Drive.

An icon with a Yellow X is a module which has been discovered automatically,

but is unable to communicate to its associated drive. It will have no name

associated as the only name could come from the drive itself. This can occur for a

couple of reasons:

• The HMI Interface Board has powered up, but the drive has not

synchronized with the HMI Interface Board. Wait 30 seconds and use the

Refresh option of the Maintenance button to initiate another discovery

process.

• The drive firmware in the associated drive is earlier than FRN 8.001 and is

unable to communicate with the HMI Interface Board module. Update

the drive firmware.

• The drive is in Download Mode. This drive will also present an “Invalid

Response” error message indicating the “Drive returned an error on

connection xxx.xxx.xxx.xxx”.

• There are more than five simultaneous Ethernet/IP connections to the

drive.

When a blue X is over the drive icon, this module was explicitly defined in the

Node List, but no communications could be made to that node. The name

displayed is the name that was supplied with the Node entry. Problems causing

this include, but are not limited to:

• Drive is powered off

• HMI Interface Board is not plugged into network

• Node address is not reachable on the network.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 89 90

No comments

Rockwell-automation 7000 PowerFlex HMI Offering with Enhanced Function User Manual Page 30