Rockwell-automation 1766-Lxxxx MicroLogix 1400 Programmable Controller User Manual download pdf (Page 381)

Rockwell Automation Publication 1766-UM001H-EN-P - May 2014 341

Connecting to Networks via Ethernet Interface Appendix G

Manually Configuring Channel 1 for Controllers on

Subnets

If you are manually configuring channel 1 for a MicroLogix 1400 controller

located on a subnet, deselect both of the “BOOTP Enable” and “DHCP Enable”

options by clicking on the checked box, as shown in the figure below.

See the table below to configure the subnet mask and gateway address fields for

each controller via your programming software.

MicroLogix 1400 Embedded

Web Server Capability

MicroLogix 1400 controllers include not only the embedded web server which

allows viewing of module information, TCP/IP configuration, and diagnostic

information, but the capabilities that also allow viewing of the data file via

Ethernet using a standard web browser.

This field: Specifies: Configure by doing the following:

Subnet Mask The controller’s subnet mask.

The subnet mask is used to interpret IP

addresses when the internet is divided into

subnets.

Enter an address of the following form:

a.b.c.d Where: a, b, c, d are between 0...255 (decimal)

If your network is not divided into subnets, then leave the subnet mask field at the

default. If you change the default and need to reset it, type 0.0.0.0.

Gateway Address The IP address of the gateway that provides a

connection to another IP network.

This field is required when you communicate

with other devices not on a local subnet.

Enter an address of the following form:

a.b.c.d Where: a, b, c, d are between 0...255 (decimal)

The default address is No Gateway.

1 2 ... 376 377 378 379 380 381 382 383 384 385 386 ... 405 406

Comments to this Manuals

No comments