Rockwell-automation 1770-KF3 DH-485 Communication Interface User Manua User Manual download pdf (Page 24)

Chapter

31

Configuring the KF3

You configure the KF3’s communication parameters using the push buttons

and displays located on the bottom of the module. The module saves them

in nonvolatile memory. Factory default settings (shown in Table 3.B)

should be adequate for most industrial usages.

Important: Verify that all parameter settings are correct for your purposes

before connecting the KF3 to your network.

The KF3 has two modes of operation, run mode and configuration

mode. During normal operation, the module functions in run mode.

Communication parameters are changed in configuration mode. The

module continues to communicate while it is in configuration mode.

Changes take effect as soon as they are saved and the module returns to run

mode. In run mode, the configuration displays are turned off.

Important: If your displays show symbols other than those shown in this

chapter, your module is malfunctioning. Contact your A-B representative.

Figure 3.1

Configuration

Display and Push Buttons

Communication

Parameter

Current

Setting

Configuration

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 58 59

No comments

Rockwell-automation 1770-KF3 DH-485 Communication Interface User Manua User Manual Page 24