Rockwell-automation Logix5000 Control System: Connect Kinetix 350 Driv User Manual download pdf (Page 5)

Rockwell Automation Publication IASIMP-QS032A-EN-P - March 2012 5

Preface

About This Publication

This quick start provides examples and procedures for integrating a Kinetix



350 drive into any

Logix5000



controllers control system over an EtherNet/IP network. The programming

examples are not complex, and offer easy solutions to verify that devices are functioning and

communicating properly.

Before Using This Publication

You can only complete the tasks described in this publication after first completing some

prequisite tasks with a Logix5000 controller. For example, before you can add a Kinetix 350

drive to an RSLogix



5000 project, as described on page 31, you must first create the project in a

Logix5000 controller.

For more information on how to complete these tasks with specific Logix5000 controllers, see

the Integrated Architecture



: Logix5000 Control Systems Quick Starts Quick Reference,

publication IASIMP-QR024

IMPORTANT

This publication describes basic example tasks you can complete when using a Kinetix 350 drive over an EtherNet/IP

network. The tasks described are not the only tasks you can complete with the drive on an EtherNet/IP network. You

will likely need to complete additional tasks when using a Kinetix 350 drive in a specific Logix5000 control system.

IMPORTANT

The example graphics shown in Table 1 - Required Tasks to Complete before Using This Quick Start on page 6 are for

CompactLogix



5370 L3 controllers. Depending on the Logix5000 controller you are using, the specific steps to

complete the tasks described in the table might vary.

1 2 3 4 5 6 7 8 9 10 ... 51 52

No comments

Rockwell-automation Logix5000 Control System: Connect Kinetix 350 Driv User Manual Page 5