Publication 1746-UM001A-US-P
Installation and Wiring 3-7
Module Installation and
Removal
When installing the module in a chassis, it is not necessary to remove
the terminal block from the module. However, if the terminal block is
removed, use the write-on label located on the side of the terminal
block to identify the module location and type.
Terminal Block Removal
To remove the terminal block:
1. Loosen the two terminal block release screws.
2. Grasp the terminal block at the top and bottom and pull
outward and down.
•
SLOT
RACK
MODULE
ATTENTION
!
Remove power before removing or inserting this
module. When you remove or insert a module with
power applied, an electrical arc may occur. An
electrical arc can cause personal injury or property
damage by:
•
sending an erroneous signal to your system’s field
devices, causing unintended machine motion.
•
causing an explosion in a hazardous environment
Electrical arcing causes excessive wear to contacts on
both the module and its mating connector. Worn
contacts may create electrical resistance.
Terminal Block Release
Screws
Comments to this Manuals