Rockwell-automation 1747-KE,D17476.12 DH-485/RS-232C Interface Module User Manual Page 129
- Page / 139
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Publication 1747-UM005B-EN-P - March 2006
Lithium Battery Replacement, Handling, and Disposal C-5
Battery Disposal
The following procedures must be followed when disposing of
lithium batteries.
For disposal, batteries must be packaged and shipped in accordance
with the transportation regulations, to a proper disposal site. The U.S.
Department of Transportation authorizes shipment of “Lithium
batteries for disposal” by motor vehicle only in regulation 173.1015 of
CRF49 (effective January 5, 1983). For additional information contact:
U.S. Department of Transportation
Research and Special Programs Administration
400 Seventh Street, S.W.
Washington, D.C. 20590
Although the Environmental Protection Agency at this time has no
regulations specific to lithium batteries, the material contained may be
considered toxic, reactive, or corrosive. The person disposing of the
material is responsible for any hazards created in doing so. State and
local regulations may exist regarding the disposal of these materials.
ATTENTION
Do not incinerate or dispose of lithium batteries in
general trash collection. Explosion or violent rupture
is possible. Batteries should be collected for disposal
in a manner to prevent against short circuiting,
compacting, or destruction of case integrity and
hermetic seal.
- DH-485/RS-232C 1
- Interface Module 1
- Important User Information 2
- Summary of Changes 3
- 2 Summary of Changes 4
- Table of Contents 5
- Table of Contents iii 7
- Who Should Use This 9
- Purpose of This Manual 9
- Terms and Abbreviations 10
- Conventions Used in This 11
- 4 Preface 12
- Features 14
- LED Indicators 15
- Jumper Placement 16
- Use a Modem with Your 17
- Use DF1 Protocol and Your 17
- Typical Configurations 18
- Half-duplex (Local Mode) 20
- Half-duplex (Remote Mode) 21
- Group 01Group 00 21
- Quick Start 23
- Procedures 24
- Configure the Module 25
- Start-up the Module 25
- 2-4 Quick Start 26
- DF1 Communication 27
- Half-duplex DF1 Protocol 28
- Local Mode 29
- Remote Mode 30
- 011 11101 34
- Slave-to-slave Communication 35
- Communicate with DH-485 36
- Communicate with a 37
- European Union Directives 39
- Compliance 39
- Choose the Module’s 40
- Functionality 40
- Series B Functionality 41
- Set the Module’s Mode 42
- Verify CONFIG Port 43
- Configuration 43
- Verify DF1 Port 44
- Install Your Module in an 45
- Open Slot 45
- Connect Cable to CONFIG or 46
- DF1 Ports 46
- 47
- Connect Cable to the 49
- DH-485 Port 49
- Configure Your SLC Chassis 51
- Configure the DF1 Driver 52
- Configure Your Module 53
- Complete the Installation of 53
- Your Module 53
- Terminal 55
- ASCII Terminal 56
- Module Configuration with 57
- Top Level Setup Menu 58
- CONFIG Port Menu 59
- DF1 Port Menu 60
- DH-485 Port Menu 61
- DF1 Protocol Menu 62
- RAM is lost 63
- DF1 Half-duplex Setup Menu 64
- Display Parameters Menu 66
- Configure the Interface 68
- Module from the SLC 68
- Processor 68
- Place the Module into 70
- Software Run Mode from 70
- SLC Processor 70
- Configuration from the SLC 71
- Read the Module’s 71
- Examine the SLC 72
- Processor’s Status Word 72
- Build the DF1 Configuration 74
- DF1 Port Setup Parameters 75
- Build the DH-485 78
- Configuration Packet 78
- Build the Modem Init String 79
- Configuration Packets 79
- Use the Real Time Clock 82
- Establish a Data Echo 83
- Between the Interface 83
- Module and the SLC 83
- Reset the Interface Module 84
- Interpret the LED Indicators 85
- Input Image Description 86
- Status Codes from the 87
- Module to the Processor 87
- SLC Fault Code 87
- Application Examples 89
- Parameter Settings 90
- Configuration Results 91
- Supplementary Example 97
- Using the Backplane 97
- Data Echo Feature 99
- Configuration Data Table 101
- RSLogix Software to SLC 102
- Network via Modem 102
- Modify an Existing Driver 105
- Add a New Driver 105
- IMPORTANT 109
- Specifications 117
- Certification 118
- Port Isolation 118
- RS-423 jumper settings 119
- A-4 Specifications 120
- Appendix 121
- Overview 121
- SLC 500 Processor 122
- Use the PLC-5 Message 123
- Instruction with Word 123
- Instruction with Byte 124
- Disposal 125
- Battery Location 126
- Battery Handling 127
- Three or More Batteries 128
- Battery Disposal 129
- DF1 Full-duplex 132
- DF1 Half-duplex 133
- Numerics 135
- 2 Index 136
- Index 3 137
- Rockwell Automation 139
Related products and manuals for Equipment Rockwell-automation 1747-KE,D17476.12 DH-485/RS-232C Interface Module
Equipment Rockwell-automation 1794-IF8IH FLEX I/O 8 Isolated Input HART Analog M User Manual
(28 pages)
(28 pages)
Equipment Rockwell-automation 1746-NI16V SLC 500 Analog Input Modules User Manua User Manual
(120 pages)
(120 pages)
Equipment Rockwell-automation 1738-OE2VM12 ArmorPoint 24V dc Analog Output Modul User Manual
(16 pages)
(16 pages)
Equipment Rockwell-automation 1771-SDN DeviceNet Scanner Module Installation Ins User Manual
(40 pages)
(40 pages)
Equipment Rockwell-automation 1771-OBD Series C INSTL INSTR DC(10-60V) OUTPUT User Manual
(20 pages)
(20 pages)
Equipment Rockwell-automation 1734-FPD, Series B POINT I/O Field Potential Distr User Manual
(16 pages)
(16 pages)
Equipment Rockwell-automation 1771-IND series C INSTL INSTR AC/DC INPUT MODULE User Manual
(12 pages)
(12 pages)
Equipment Rockwell-automation 1734D-IB8XOB8 POINT I/O Installation Instructions User Manual
(12 pages)
(12 pages)
Equipment Rockwell-automation 1771-N SERIES High Resolution Analog Module User M User Manual
(188 pages)
(188 pages)
Equipment Rockwell-automation 1792D-8BIO8E ArmorBlock MaXum 8 Input/8 Output Mod User Manual
(16 pages)
(16 pages)
Equipment Rockwell-automation Logix5000 Controllers Major, Minor, and I/O Faults User Manual
(53 pages)
(53 pages)
Equipment Rockwell-automation 1756-HIST2G FactoryTalk Historian ME 2.2 Installat User Manual
(28 pages)
(28 pages)
Equipment Rockwell-automation 1769-IQ6XOW4 Compact Combination 24V dc Sink/Sourc User Manual
(20 pages)
(20 pages)
Equipment Rockwell-automation 1746-NO8V SLC 500 8-Point Analog Output Module/ Us User Manual
(74 pages)
(74 pages)
© 2020, manymanuals.com. All rights reserved. | 3.041 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals