Rockwell-automation 2705 RediSTATION Operator Interface User Manual User Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
Publication 2705-UM001A-EN-P
2-2 Installation and Mounting
Removing the Enclosure
Cover
To set the configuration parameters of the RediSTATION and mount
the enclosure, you must remove the enclosure cover.
To remove the enclosure cover:
1. Using a slotted screwdriver, remove the 6 cover screws.
2. Carefully remove the cover so as not to disconnect any wires.
3. Remove the DeviceNet terminal block connector from the circuit
board. Do not disconnect any wiring.
4. Store the enclosure cover in a safe location; it is not required for
mounting the enclosure.
Setting the DIP Switches
The setting of the DIP switch on the circuit board determines:
DeviceNet node address
DeviceNet data rate
Output fault state
Output flash rate
The location of the DIP switch and the factory defaults are shown
below.
Cover Assembly
Removable Terminal
Block Connector
1
2345678910
OFF = 0
ON = 1
DIP Switches
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 63 64

Comments to this Manuals

No comments