Rockwell-automation 2711PC-xxxx PanelView Plus Compact User Manual User Manual download pdf (Page 104)

104 Publication 2711PC-UM001A-EN-P - March 2009

Chapter 7 Upgrading Firmware

12. After the terminal resets twice, the new firmware is installed.

• On touch-screen terminals, you must calibrate the touch

screen after the first terminal reset by selecting pointers in all

four corners of the screen and pressing the middle of the

screen when prompted.

• Communication settings are cleared when the terminal is

upgraded. If Ethernet communication is used, reconfigure the

Ethernet settings using the values recorded when preparing

the terminal for the upgrade. Refer to Prepar

ing Terminal for

Upgrade on page 95.

13. Replace the .MER files that you backed up before starting the

upgrade or download the new .MER files to the terminal.

14. Load the .MER file and run the project.

IMPORTANT

Ignore this message if it appears during the upgrade.

Machine Edition may be corrupted. Do you want to

download firmware?

It means FactoryTalk View Machine Edition has been

removed from the terminal to install the upgrade. Do

NOT touch the two buttons that appear with the

message. Doing so could render the terminal inoperable.

TIP

You can configure your application to start automatically

on power cycle by accessing Terminal Settings>Startup

Options in Configuration mode.

1 2 ... 99 100 101 102 103 104 105 106 107 108 109 ... 131 132

Comments to this Manuals

No comments