Rockwell-automation 2711PC-xxxx PanelView Plus Compact User Manual User Manual download pdf (Page 77)

Publication 2711PC-UM001A-EN-P - March 2009 77

Installing and Replacing Components Chapter 5

4. Carefully lift the logic module away from the terminal and flip

over to expose the circuit board.

5. Locate the battery on the circuit board.

6. Remove the battery by lifting up the side of the battery.

7. Insert the new battery.

8. Attach the logic module by aligning the two connectors on the

bottom of the module with the connectors on the terminal.

9. Push down on the logic module until firmly seated.

10. Tighten the six captive screws that secure the logic module to a

torque of 0.58 N•m (5…7 lb•in).

ATTENTION

Wear a properly grounded ESD wristband before

touching any of the electronic components in the

logic module.

Remove battery by lifting up the

edge indicated by arrow.

IMPORTANT

Use only catalog number 2711P-RY2032 to replace the

battery.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 131 132

Comments to this Manuals

No comments