Rockwell-automation 7000 PowerFlex HMI Offering with Enhanced Function User Manual download pdf (Page 85)

Rockwell Automation Publication 7000-UM201B-EN-P - June 2013 83

Hardware Appendix A

Ethernet Port

The standard RJ45 connector for Ethernet. The port is configured for 100 Mbps,

Full Duplex. A standard Cat5 Ethernet cable is used for connection.

DIM (Drive Identity Module) Socket

The HMI Interface Board module plugs into the DPM via the existing DIM

socket on the DPM. To accommodate the existing external DIMs, the DIM can

be reinserted into the socket on the PFNI board.

Hardware Reset Button

The reset push button (SW1) on the PFNI board restarts the HMI Interface

Board module. This switch does not cause any direct action to occur within the

drive control. Any communications currently active with the Drive will be

disconnected by pressing this button.

USB Port

The USB port on the HMI Interface Board module will be used to replace the

functionality of the RS232 Data Port on the DPM (not currently available). The

majority of PCs and Laptops no longer support a serial port. For these devices,

the USB port can be used instead. A standard type A-B cable is required.

The functionality of the port can be changed by DIP Switch (SW2), (refer to

DIP Switch Settings

on page 81).

Windows XP and Windows 7 drivers for the USB Port can be found at the

following website: http://www.silabs.com/products/mcu/Pages/

USBtoUARTBridgeVCPDrivers.aspx

SD Card Socket

This socket contains an SD Card used to store the majority of files which are

available via the HMI Interface Board.

The SD Card contains a Write Protect Tab. When the Tab is in the upper

position (tab on the left of the card), the card can be written to. If you want to

protect against any updates to the drive over the network, this tab can be set to

the lower position. The lower position is a write protect position and no contents

on the card can be modified.

IMPORTANT

This card should not normally be removed. Removing the card reduces the

functionality of the HMI Interface Board.

Upper Position Card is open for writing

Lower Position Card is write-protected

1 2 ... 80 81 82 83 84 85 86 87 88 89 90

No comments

Rockwell-automation 7000 PowerFlex HMI Offering with Enhanced Function User Manual Page 85