216 Publication 2711-UM014G-EN-P - September 2008
Chapter 12 Terminal Connections
Ethernet Connector
The Ethernet connector is an RJ45, 10/100Base-T connector. This is
the pinout for the connector.
When to use a straight-through and cross-over pin-out:
• Direct point-to-point 10/100Base-T cables, with cross over
pin-out (1-3, 2-6, 3-1, 6-2), connect the PanelView Ethernet port
directly to another SLC 5/05 Ethernet port (or a computer
10/100Base-T port).
Cables
Category 5 shielded and unshielded twisted-pair cables with RJ45
connectors are supported. The maximum cable length between the
PanelView Ethernet port and a 10/100Base-T port on an Ethernet hub
(without repeaters or fiber) is 100 m (328 ft). However, in an industrial
application, the cable length should be kept to a minimum.
Pin Pin Pin Name
RJ45
Connector
1TD+
2TD-
3RD+
4NC
5NC
6RD-
7NC
8NC
ATTENTION
If you connect or disconnect the Ethernet cable with power
applied to the PanelView or any device on the network, an
electrical arc can occur. This could cause an explosion in
hazardous location installations. Be sure that power is removed
or the area is nonhazardous before proceeding.
1
8
Comments to this Manuals