Rockwell-automation MPAS Integrated Linear Stages User Manual download pdf (Page 62)

62 Rockwell Automation Publication MP-UM001D-EN-P - September 2013

Chapter 8 Removing and Replacing Components

Cable Carrier Assembly

Removal

Follow these directions to remove the cable carrier assembly.

1. Remove the four pan head screws from junction box side cover.

2. Remove the two button head cap screws (BHCS) from the junction box

cover.

3. Remove the junction box cover assembly.

Figure 14 - Cable Carrier Removal

4. Separate the motor power connector by squeezing the side tabs and pulling

on the housing, but do not pull on the wires.

5. Separate the feedback connector from the circuit board by pushing on the

center tab and pulling up on the connector housing, but do not pull on the

wires.

6. Remove the two SHCS from the cable carrier angle bracket.

7. Lay the cable carrier out flat and mark the location of the end bracket.

8. Loosen, but not remove, the two SHCS securing the end bracket to the

base of the linear stage.

9. Remove the cable carrier.

Cable Carrier Assembly

Installation

Follow the Cable Carrier Assembly Removal procedure in reverse.

TIP

Mark the location of the end bracket before removing the cable carrier, this

makes it easier to align it when reinstalling.

Junction Box Side Cover

Junction Box Cover

Cable Carrier Module

Angle Bracket

End Bracket

Feedback Connector

Motor Power Connector

M3 0.5 X8 LG

Phillips Pan Head Screws (4x)

M4 X 0.7 X 8 LG BHCS (2x)

M4 X 0.7 X 10

LG SHCS (2x)

M3 X 0.5 X 8

LG SHCS (2x)

ATTENTION:

Never pull on wires when disconnecting power and feedback

connectors. Damage to circuit continuity can occur.

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 111 112

Comments to this Manuals

No comments

Rockwell-automation MPAS Integrated Linear Stages User Manual Page 62

Comments to this Manuals

Related products and manuals for Equipment Rockwell-automation MPAS Integrated Linear Stages